|
|
|
| Copyright © 2003-2008 EspressoID® | |
 |
|
EspressoID
Inkjet Printer Set-up Notes
Note:
If using a PVC card printer, simply select the PVC card size
and orientation from the drop down menu in EspressoID®.
This page is specifically for Epson Inkjet Printers.
Use this guide to help set-up your Epson Inkjet Printer for printing on
Teslin.
For more help see Making Teslin
ID Badges.
1)
Go to your
printer folder by Clicking START, SETTINGS, PRINTERS &
FAXES.
2) Right click the Epson Printer
3) Select Properties
4) Click the ADVANCED TAB
5) Click the PRINTING DEFAULTS Button
6) Select the MAIN TAB if is not already selected
7) From the top drop down box, select Bright White Paper
8) From the middle drop down box select Normal
9) From the bottom drop down box select USER DEFINED
10) A window will open
11) For paper Size Name type in Espresso
12) For paper width type in 400
13) For paper height type in 600
14) Under units .01 should be selected
15) Click Save, Then OK and this window will close
16) Under Orientation make sure that Landscape is selected.
17) Click Save Setting Button
18) Type in a name such as Espresso. Click the SAVE button
19) Click the OK button and this box will close
20) Click OK again and the Main properties box will close.
21)
After installing the software, you’ll select this printer and set-up from
TEMPLATE, PAGE SETTINGS in the EspressoID Menu.
Other settings: While
in Espresso click START, TEMPLATE, PRINTER AND SELECT THE EPSON Printer.
When you are designing your template (Tab 2 in Espresso) click template and
select Teslin CR-80 or whatever size Teslin you had selected.
Note: If you
have trouble with sheets not going through the printer take each sheet and
place it in a carrier, than run through your laminator prior to printing.
This will totally flatten the sheet and allow the printer to properly feed
the sheet. We suggest placing one sheet at a time in your printer tray. If
you are printing both sides with a laser or inkjet printer, the software
will first print the front and than prompt you to reinsert the sheet to
print the back.
For more help see Making Teslin
ID Badges.
